home *** CD-ROM | disk | FTP | other *** search
-
-
- - Timeclock I, Version 2.3s - INSTALL.DOC -
-
-
- T I M E C L O C K I
- --------------------------
-
- Version 2.3s
- --------------
-
- U S E R I N S T A L L A T I O N
- --------------------------------
-
- I N S T R U C T I O N S
- --------------------------------------
-
- Last updated: April, 1993
-
- TimeClock I can be installed in just a few minutes. If you are an
- experienced PC user, just make a new directory (typically TC) and
- copy on the distribution disk(s), then execute TC23S.EXE (A self-
- expanding archive). If you are not so experienced please perform the
- following steps.
-
- 1. Starting a the C> prompt type MD C:\TC then press the Return
- or Enter key. This creates a new sub-directory called TC.
- (You may substitute any valid drive for C:)
-
- 2. Now type CD TC and press the Enter key. You are now logged
- into the TC sub-directory.
-
- 3. Place the TimeClock distribution disk in your A drive
- (floppy) and close the gate.
-
- 4. Type COPY A:*.* then press the Enter key. The files from the
- distribution disk will be copied into the TC sub-directory.
-
- 5. Type TC23S and press the Enter Key. This is a self-expanding
- archive program and will produce the needed program files.
-
- 6. Print the PACKING.LST file (COPY PACKING.LST PRN) and verify
- that you have all of the required files.
-
- 7. Print the TC23S.DOC file (COPY TC23S.DOC PRN) to get the manual
- and proceed with the simple setup instructions. You can enter
- (COPY *.DOC PRN) and print all the .DOC files.
-
- Note! The TimeClock program will open 13 files. Your CONFIG.SYS
- file should have a FILES= statement with at least this number.
- FILES=20 is a good choice for most programs.
-
-
-
-
-
-
-
-
-
-
-
- Installation Information Page 1 of 1